BRIO CLBL720SC INSTRUCTION MANUAL Pdf Download (2024)

FAQs

How do you reset the Brio filter alarm? ›

Press the filter reset button until the red indicator light turns off. Keep this dispenser in a dry and cool place and avoid direct sunshine .

F6 Leak Sensor Troubleshooting

If your cooler is beeping, this typically indicates an issue with the leak sensor.

If the 3 lights are flashing, a leak was detected. The pipe is not connected properly . Check all water connections and tubes to ensure everything is connected properly . The water and PE pipes have burst .

To reset the beeping noise, push the up arrow and down arrow together until the clock blinks. Than press the up arrow for reset. The sound will beep every 6 months to tell you to replace the filters.

This is the place for replacement cartridges and filters for Brio, the innovative air purifier. Brio's APART cartridge should last a year or longer under typical conditions. The Refresh Plus filter should be changed every 24 months.

Locate the reset button, usually found beneath the status light on the control panel. Press and hold the button for three seconds or until you hear a beep or chirp. Once the appliance makes a noise, you can release the button and close your fridge.

You can use the self cleaning feature whenever you want just keep in mind that once active, you cannot dispense water for 30 minutes. We recommend cleaning your cooler 2-4 times a month possibly before you go to bed.

If you are getting a F7 error code with your Brio Water dispenser, this typically indicates continuous water production for 90 minutes without the reservoir being full, which may be due to a leak or moisture affecting the sensors.

On average, appliances like water dispensers and water coolers require servicing or replacement of parts every six months. You should never leave a filter unchanged for one year or longer to ensure optimal performance and avoid impurity buildup and machine damage.

Four Reasons The Light On Your Water Heater is Blinking

A Thermostat Problem. The Pilot Light Is out. Empty Tank or Tank Won't Fill Up. Power or Electrical Issues.

Why is the red light flashing on my water dispenser? ›

A flashing red function light alerts you when your bottle is empty. Replace the bottle as soon as possible. CAUTION: Do not dispense hot, cool or cold water if the red light is flashing as you could empty the tanks and cause the dispenser to overheat.

F6 Leak Sensor TroubleshootingUpdated 2 months ago

In the event that your cooler is emitting a beeping sound, this typically indicates an issue with the leak sensor. Please follow these steps to troubleshoot: 1. Dry the Sensor: Locate the grey sensor inside the lower cabinet of the unit.

To activate the self-cleaning cycle, press the ozone switch, hold for 5 seconds, then release. During the cleaning cycle, ozone is produced and injected into the water system. This ozone kills bacteria and biofilms typically found in water dispensers.

The majority of Brio water dispensers provide an external switch that controls the power supply to the cooling and heating machinery within the water cooler. Ensure that the cold water switch is turned to the "On" position and allow enough time for water to cool.

A continuous beep for an infinite time. In case, such an alarm is audible, kindly switch off the purifier and call the service technician to replace the filters. In such a circ*mstance, the purifier will not function unless the filters are changed.