BRIO CLCTPOU620UVF2 INSTRUCTION MANUAL Pdf Download (2024)

FAQs

How do you reset the Brio filter alarm? ›

Press the filter reset button until the red indicator light turns off. Keep this dispenser in a dry and cool place and avoid direct sunshine .

F6 Leak Sensor Troubleshooting

If your cooler is beeping, this typically indicates an issue with the leak sensor.

To reset the beeping noise, push the up arrow and down arrow together until the clock blinks. Than press the up arrow for reset. The sound will beep every 6 months to tell you to replace the filters.

If the 3 lights are flashing, a leak was detected. The pipe is not connected properly . Check all water connections and tubes to ensure everything is connected properly . The water and PE pipes have burst .

We recommend replacing your filters every six to 12 months, but it depends on your water habits.

On average, appliances like water dispensers and water coolers require servicing or replacement of parts every six months. You should never leave a filter unchanged for one year or longer to ensure optimal performance and avoid impurity buildup and machine damage.

You can use the self cleaning feature whenever you want just keep in mind that once active, you cannot dispense water for 30 minutes. We recommend cleaning your cooler 2-4 times a month possibly before you go to bed.

The average lifespan is seven years, assuming even frequent usage. We recommend you treat your dispenser like your car when it comes to arranging checkups and servicing.

The water pressure must be between 40 and 120 psi (pounds per square inch).

Tankless water heaters can emit beeping noises due to various reasons, including pressure sensors, temperature sensors, error codes, or faulty components. Common causes of tankless water heater beeping include low gas supply, insufficient water flow, overheating, or malfunctioning components.

What is the code F7 on a Brio water dispenser? ›

If you are getting a F7 error code with your Brio Water dispenser, this typically indicates continuous water production for 90 minutes without the reservoir being full, which may be due to a leak or moisture affecting the sensors.

The majority of Brio water dispensers provide an external switch that controls the power supply to the cooling and heating machinery within the water cooler. Ensure that the cold water switch is turned to the "On" position and allow enough time for water to cool.

At the top, on the activation button, is an LED light that indicates the battery charge status. This light stays red as long as it needs to be charged and turns off when the charge is complete.

A continuous beep for an infinite time. In case, such an alarm is audible, kindly switch off the purifier and call the service technician to replace the filters. In such a circ*mstance, the purifier will not function unless the filters are changed.

To reset the filter alarm, change the filters and hold down the key with the “Filter” symbol until the exclamation mark in the symbol disappears.